Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1 -5
- Perform inspection of A/F sensor signal related parts.
Step 6
- Verify that the primary malfunction is resolved and there are no other malfunctions.

TROUBLESHOOTING DIAGNOSTIC PROCEDURE

STEP	INSPECTION	RESULTS	ACTION
1	PURPOSE: INSPECT A/F SENSOR CONNECTOR CONDITION Switch the ignition off. Disconnect the A/F sensor connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the connector and/or terminals, then go to Step 6.
1		No	Go to the next step.
2	PURPOSE: INSPECT INSTALLATION OF A/F SENSOR Inspect installation of A/F sensor. Is the A/F sensor installed securely?	Yes	Go to the next step.
2		No	Retighten the A/F sensor, then go to Step 6. (See AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION [VIN Y] .)
3	PURPOSE: VERIFY IF MALFUNCTION RELATED TO EMISSION SYSTEM AFFECTS A/F SENSOR SIGNAL Inspect for exhaust gas leakage from the exhaust system. (between A/F sensor and HO2S) Is there any malfunction?	Yes	Repair or replace the malfunctioning part according to the inspection results, then go to Step 6.
3		No	Go to the next step.
4	PURPOSE: DETERMINE INTEGRITY OF A/F SENSOR Reconnect all disconnected connectors. Inspect the A/F sensor. (See AIR FUEL RATIO (A/F) SENSOR INSPECTION [VIN Y] .) Is there any malfunction?	Yes	Replace the A/F sensor, then go to Step 6. (See AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION [VIN Y] .)
4		No	Go to the next step.
5	PURPOSE: DETERMINE INTEGRITY OF A/F SENSOR HEATER Inspect the A/F sensor heater. (See AIR FUEL RATIO (A/F) SENSOR INSPECTION [VIN Y] .) Is there any malfunction?	Yes	Replace the A/F sensor, then go to the next step. (See AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION [VIN Y] .)
5		No	Go to the next step.
6	PURPOSE: VERIFICATION OF VEHICLE REPAIR COMPLETION Always reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC .) Implement the repeatability verification procedure. (See Repeatability Verification Procedure .) Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [VIN Y] .)
6		No	DTC troubleshooting completed.