DTC P0096-00: IAT Sensor No. 2 Circuit Range/Performance Problem: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P0096:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0096:00	IAT sensor No. 2 circuit range/performance problem
DETECTION CONDITION	Any one of the following conditions is met: The condition has continued for 2 s in which difference in intake air temperature measured by the IAT sensor No. 2 and IAT sensor No. 1 is 17 °C {31 °F} or more or -26 °C {-47 °F} or less. The condition has continued for 2 s in which difference in intake air temperature measured by the boost air temperature sensor and IAT sensor No. 2 is 17 °C {31 °F} or more or -26 °C {-47 °F} or less. MONITORING CONDITIONS Period vehicle being left: 6 h or more Battery voltage: 8 V or more Within 20 s after engine start The following DTCs are not detected: Boost air temperature sensor: P007C:00 and P007D:00 IAT sensor No. 1: P0112:00, P0113:00 IAT sensor No. 2: P0097:00 and P0098:00 Diagnostic support note This is a continuous monitor (CCM). The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA/Snapshot data is available. DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	Not applicable
POSSIBLE CAUSE	MAP sensor/IAT sensor No. 2 connector or terminals malfunction IAT sensor No. 2 malfunction PCM connector or terminals malfunction PCM malfunction
SYSTEM WIRING DIAGRAM	Not applicable