Details On DTCs

WARNING: This page is about a different variant/trim than selected.

DTC B10A2:00 (PCM, VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

DESCRIPTION	Vehicle collision
DETECTION CONDITION	Determination conditions	A collision signal from the SAS control module is received.
	Preconditions	Not applicable.
	Drive cycle	1
	Self test type	CMDTC self test
	Sensor used	PCM
FAIL-SAFE FUNCTION	Stops fuel injection control Stops fuel pump control Stops ignition control Stops engine coolant fan control
VEHICLE STATUS WHEN DTCs ARE OUTPUT	Stops fuel pump operation when ignition is switched ON Delays starter operation during cranking for maximum 1.2 s.
POSSIBLE CAUSE	Vehicle is involved in collision (collision signal from SAS control module is received) SAS control module malfunction PCM malfunction