Engine coolant temperature compensation inspection

WARNING: This page is about a different variant/trim than selected.

Connect the M-MDS to the DLC-2.
Select the following PIDs: (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN Y)] .)
- ECT
- IAT
- RPM
Verify that the engine is cold, then start the engine.
Verify that the engine speed decreases as the engine warms up.
- If the engine speed does not decrease or decreases slowly, inspect the following:
  - ECT sensor and related wiring harness (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION .)
  - Throttle body and related wiring harness (See THROTTLE BODY INSPECTION .)