LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Sport, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (VIN Y)) >> Engine Oil Solenoid Valve Inspection >> Engine Oil Solenoid Valve Operation Inspection

Engine Oil Solenoid Valve Operation Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine oil solenoid valve. (See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION .)
  2. Verify that the battery is fully charged.
  3. Connect the battery to the engine oil solenoid valve connector (2 terminals) as shown in the figure.
    G12228835Courtesy of MAZDA MOTORS CORP.
  4. Verify that there is an operation sound from the engine oil solenoid valve when applying battery voltage between engine oil solenoid valve connector terminals A and B.
    • If the operation sound cannot be heard, replace the engine oil solenoid valve.
    NOTE:
    • A click sound is heard when the engine oil solenoid valve operates normally.
  5. Install the engine oil solenoid valve. (See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals