LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Signature >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Oil Seal Replacement [FW6AX-El, GW6AX-El] >> Transfer Oil Seal (RH) No. 1

Transfer Oil Seal (RH) No. 1

  1. Remove the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
  2. Insert a flathead screwdriver into the notch of the transfer and remove the oil seal (RH) No. 1.
    G11427296Courtesy of MAZDA MOTORS CORP.
  3. Install the new transfer oil seal (RH) No. 1 projection to within the range shown in the figure.
    G11427297Courtesy of MAZDA MOTORS CORP.
  4. Using the SST and a hammer, tap the new seal into place.
    G11427298Courtesy of MAZDA MOTORS CORP.
  5. Coat the lip of the oil seal with transfer oil.
  6. Install the front drive shaft (RH). (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals