Oil Pressure Switch Removal/Installation (Us): Notes
WARNING: This page is about a different variant/trim than selected.
Replacement Part
| Bolt Quantity: 16 Location of use: Oil pan |
Oil and Chemical Type
| Sealant Type: TB1217E or equivalent |
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.
- Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or sludge could spatter and get into the eyes.
CAUTION:
- If the oil pressure switch has been replaced, perform initial learning. (See INITIAL LEARNING (US) .)