Initial learning procedure
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS.
- Perform the automatic transaxle initial learning.
- Using the M-MDS, verify that DTC P06B8:00 has not been stored. (See
DTC INSPECTION)DTC P06B8-00:
.) (See DTC INSPECTION
.)
- If DTC P06B8:00 is displayed, switch the ignition off and repeat the procedure from Step 1.
- If any other DTCs are displayed, repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL, ET6AX-EL )