LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostics - Automatic Transaxle (EV6A-El, EV6AX-El)) >> DTC P1783-00: Automatic Transaxle Protection Control >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P1783:00 (TCM, EV6A-EL, EV6AX-EL) DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
  • Record the freeze frame data/snapshot data.
    NOTE:
    • Recording can be facilitated using the screen capture of the PC function.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
  • Verify related Service Bulletins, online repair information, or Service Information availability.
  • Is any related information available?
 Yes Perform repair or diagnosis according to the available information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 ALLOW THE VEHICLE TO COOL DOWN FOR A WHILE
  • Switch the ignition OFF and allow the vehicle to cool down for a while.
 - Go to the next step.
Repair completion verification VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC using the M-MDS. (See CLEARING DTC .)
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Start the engine and wait for 10 s or more.
  • Perform the DTC inspection using the M-MDS. (See DTC INSPECTION .)
  • Are any DTCs present?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (EV6A-EL, EV6AX-EL) (US)] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals