DTC P0768-00: Shift Solenoid No. 4 Circuit Malfunction: Outline

WARNING: This page is about a different variant/trim than selected.

DTC P0768:00 (TCM, EV6A-EL, EV6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Shift solenoid No. 4 circuit malfunction
Detection condition	Under the following condition, the TCM detects the shift solenoid No. 4 circuit malfunction: Battery voltage is 10.5 V or more.
Fail-safe	Set to emergency mode. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
Possible cause	Short or open circuit in shift solenoid No. 4 circuit Shift solenoid No. 4 malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable