Engine Oil Solenoid Valve Operation Inspection
WARNING: This page is about a different variant/trim than selected.
- Remove the engine oil solenoid valve. (See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION .)
- Verify that the battery is fully charged. (See BATTERY INSPECTION (US) .)
- Connect the battery to the engine oil solenoid valve connector (2 terminals) as shown in the figure.
- Verify that there is an operation sound from the engine oil solenoid valve when applying battery voltage between engine oil solenoid valve connector terminals A and B.NOTE:
- A click sound is heard when the engine oil solenoid valve operates normally.
- If the operation sound cannot be heard, replace the engine oil solenoid valve. (See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION .)
- Install the engine oil solenoid valve. (See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION .)