Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.

DTC P2855:00 (TCM, ET6A-EL, ET6AX-EL, US) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT ATF LEVEL Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [ET6A-EL, ET6AX-EL (US)] .) Is there any malfunction?	Yes	Adjust the ATF level to the specification, then go to repair completion verification. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [ET6A-EL, ET6AX-EL (US)] .)
1		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (VIN 7, VIN L) (US)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (VIN 7, VIN L) (US)] .)
Repair completion verification	VERIFY DTC TROUBLESHOOTING COMPLETED Perform the following procedure to ensure that the DTC has been resolved: Verify that the ATF temperature is 30 °C {86 °F} or more. Perform the following operation 20 times. Operate the selector lever from N to D position and wait for 5 s or more. Operate the selector lever from D to N position and wait for 5 s or more. Clear the DTC using the M-MDS. (See CLEARING DTC .) Perform the DTC inspection using the M-MDS. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (VIN 7, VIN L) (US)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (VIN 7, VIN L) (US)] .)
Repair completion verification		No	DTC troubleshooting completed.