DTC P0717-00: Open Circuit In Turbine/Input Shaft Speed Sensor Circuit: Outline
WARNING: This page is about a different variant/trim than selected.
DTC P0717:00 (TCM, ET6A-EL, ET6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Open circuit in turbine/input shaft speed sensor circuit |
| Detection condition |
- Under the following conditions, the turbine/input shaft speed sensor signal is not input for 1 s:
- Engine is running.
- Vehicle speed signal related DTC is not recorded.
- Vehicle speed is 16 km/h {9.9 mph} or more.
- There is no correlation between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal.
- DTC U0121:00 is not recorded.
|
| Fail-safe |
- Set to TCC control.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
- Inhibits 5GR and 6GR.
- Inhibits shift down when the accelerator pedal is depressed.
|
| Possible cause |
- Turbine/input shaft speed sensor malfunction
|
| System wiring diagram |
|
| Connector diagram |
|