DTC P0716-00: Turbine/Input Shaft Speed Sensor Range/Performance Problem: Outline

WARNING: This page is about a different variant/trim than selected.

DTC P0716:00 (TCM, ET6A-EL, ET6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Turbine/input shaft speed sensor range/performance problem
Detection condition	Under the following condition, the turbine/input shaft speed is 9, 00 rpm or more for 1 s: Battery voltage is 8 V or more.
Fail-safe	Set to TCC control. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS. Inhibits 5GR and 6GR. Inhibits shift down when the accelerator pedal is depressed.
Possible cause	Turbine/input shaft speed sensor malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable