DTC P0707-00: Transaxle Range Sensor Circuit Low Input: Outline

WARNING: This page is about a different variant/trim than selected.

DTC P0707:00 (TCM, ET6A-EL, ET6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Transaxle range sensor circuit low input
Detection condition	Under the following condition, incorrect voltage in any one of transaxle range sensors 1 to 4: Battery voltage is 8 V or more.
Fail-safe	Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
Possible cause	Transaxle range sensor (built-into TCM) malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable