LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (On-Board Diagnostic - Engine Control System (VIN L & VIN M) (3 Of 4)) >> DTC P2610:00 [Pcm (SKYACTIV-G)] >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P2610:00 (PCM, SKYACTIV-G) DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
  • Record the freeze frame data/snapshot data.
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
  • Verify related Service Bulletins, on-line repair information, or Service Information availability.
  • Is any related Information available?
 Yes Perform repair or diagnosis according to the available information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY BODY CONTROL MODULE (BCM) DTC
  • Perform the DTC inspection for the body control module (BCM). (See DTC INSPECTION .)
  • Are any DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See DTC TABLE [BODY CONTROL MODULE (BCM) (US)] .)
No Go to the next step.
4 INSPECT BODY CONTROL MODULE (BCM) BACKUP VOLTAGE CIRCUIT
  • Switch the ignition off.
  • Remove the MAIN 200 A fuse, F27 25 A fuse and F50 15 A fuse.
  • Inspect the MAIN 200 A fuse, F27 25 A fuse and F50 15 A fuse.
  • Is there any malfunction?
 Yes Replace the malfunctioning fuse.
Switch the ignition ON (engine on) and wait for 10 s or more.
Switch the ignition off.
Go to repair completion verification.
No Replace the body control module (BCM) and perform the repair completion verification.
(See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION [(US)] .)
Repair completion verification 1 VERIFY THAT VEHICLE IS REPAIRED
  • Install/connect the part removed/disconnected during the troubleshooting procedure.
    NOTE:
    • DTC P2610:00 can be cleared by performing the engine start and stop procedure.
  • Start the engine.
  • Stop the engine.
  • Clear the DTC recorded in the memory. (See CLEARING DTC .)
  • Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
  • Perform the DTC inspection for the PCM. (See DTC INSPECTION .)
  • Is the same Pending DTC present?
 Yes Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(US)] .)
If the CAN communication is normal, perform the diagnosis from Step 1.
No Go to the next step.
Repair completion verification 2 VERIFY IF OTHER DTCs DISPLAYED
  • Perform the DTC inspection. (See DTC INSPECTION .)
  • Are any other DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals