LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (On-Board Diagnostic - Engine Control System (VIN L & VIN M) (2 Of 4)) >> DTC P064D:00 [Pcm (SKYACTIV-G (Us))] >> Troubleshooting Diagnostic Procedure >> Intention of troubleshooting procedure

Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.
TROUBLESHOOTING DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 PURPOSE: PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS PCM
  • Clear the DTC recorded in the memory. (See CLEARING DTC .)
  • Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
  • Perform the DTC inspection for the PCM. (See DTC INSPECTION .)
  • Is the same Pending DTC present?
 Yes Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(US)] .)
If the CAN communication is normal, replace the PCM and perform the repair completion verification.
(See PCM REMOVAL/INSTALLATION (VIN M) .)
(See PCM REMOVAL/INSTALLATION (VIN 7, L) .)
No Go to the next step.
Repair completion verification PURPOSE: VERIFY IF OTHER DTCs DISPLAYED
  • Perform the DTC inspection. (See DTC INSPECTION .)
  • Are any other DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals