When idling cannot be continued
WARNING: This page is about a different variant/trim than selected.
- Remove the OCV for hydraulic variable valve timing system. (See OCV FOR HYDRAULIC VARIABLE VALVE TIMING SYSTEM REMOVAL/INSTALLATION .)
- Verify that the spool valve is at maximum advanced position.
- If there is a malfunction, replace the OCV for hydraulic variable valve timing system. (See OCV FOR HYDRAULIC VARIABLE VALVE TIMING SYSTEM REMOVAL/INSTALLATION .)
- Connect the OCV for hydraulic variable valve timing system connector.
- Switch the ignition ON (engine off).
- Verify that the spool valve is at the maximum advanced position.
- If the spool valve is stuck in the retard direction, inspect for the following:
- Short circuit in wiring harnesses or connectors between OCV for hydraulic variable valve timing system and PCM
- If the spool valve is stuck in the retard direction, inspect for the following:
- Inspect the hydraulic variable valve timing actuator. (See OCV FOR HYDRAULIC VARIABLE VALVE TIMING SYSTEM REMOVAL/INSTALLATION .)