Idle Speed Inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The idle speed cannot be adjusted.
- The M-MDS is required to verify the idle speed.
- Prepare for the engine tune-up. (See ENGINE TUNE-UP PREPARATION .)
- Verify that the idle speed (M-MDS PID: RPM) is within the specification using the PID/data monitor function of the M-MDS. (See PCM INSPECTION .)
- If there is a malfunction, refer to "ENGINE SYMPTOM TROUBLESHOOTING".
Idle speed (MTX: Neutral position, ATX: P position or N position)
MTX : 560-660 RPM
ATX : 550-650 RPM