LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Exhaust System (VIN M)) >> Exhaust System Removal/Installation >> Exhaust Manifold Insulator Installation Note

Exhaust Manifold Insulator Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Temporarily tighten the exhaust manifold insulator.
  2. Tighten the exhaust manifold insulator in the order shown in the figure.
    Fig 1: Exhaust Manifold Insulator Bolts Tightening Sequence (2WD)
    G13557368Courtesy of MAZDA MOTORS CORP.
  3. Install the insulators shown in the figure.
    Fig 2: Insulator, Nut And Bolt With Torque Specification (2WD)
    G13175118Courtesy of MAZDA MOTORS CORP.
  4. Install the purge solenoid valve component.
    G12184373Courtesy of MAZDA MOTORS CORP.
  5. Install the wiring harness clip shown in the figure.
    G12184372Courtesy of MAZDA MOTORS CORP.
  6. Install the bolts shown in the figure. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
    G12184371Courtesy of MAZDA MOTORS CORP.
  7. Install the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)


  1. Temporarily tighten the exhaust manifold insulator.
  2. Tighten the exhaust manifold insulator in the order shown in the figure.
    Fig 1: Exhaust Manifold Insulator Bolts Tightening Sequence (AWD)
    G13557368Courtesy of MAZDA MOTORS CORP.
  3. Install the insulators shown in the figure.
    Fig 2: Insulator, Nut And Bolt With Torque Specification (AWD)
    G13175118Courtesy of MAZDA MOTORS CORP.
  4. Install the purge solenoid valve component.
    G12184373Courtesy of MAZDA MOTORS CORP.
  5. Install the wiring harness clip shown in the figure.
    G12184372Courtesy of MAZDA MOTORS CORP.
  6. Install the bolts shown in the figure. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
    G12184371Courtesy of MAZDA MOTORS CORP.
  7. Install the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)