LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Exhaust System (VIN L)) >> Exhaust System Removal/Installation >> 2WD >> Exhaust Manifold Installation Note

Exhaust Manifold Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Temporarily tighten the exhaust manifold installation nuts (1) and (2) shown in the figure by hand.
    Fig 1: Exhaust Manifold Nuts Tightening Sequence (2WD)
    G13557330Courtesy of MAZDA MOTORS CORP.
  2. Tighten the exhaust manifold installation nuts (1) and (2) shown in the figure.
    Fig 2: Exhaust Manifold Nuts With Torque Specification (2WD)
    G13557331Courtesy of MAZDA MOTORS CORP.
  3. Temporarily tighten the exhaust manifold installation nuts (3) to (5) shown in the figure by hand.
    Fig 3: Exhaust Manifold Nuts Tightening Sequence (2WD)
    G13557332Courtesy of MAZDA MOTORS CORP.
  4. Tighten the exhaust manifold installation nuts (3) to (5) shown in the figure.
  5. Tighten the exhaust manifold installation nuts (1) and (2) shown in the figure.
  6. Temporarily tighten the bolts (6) and (7) shown in the figure.
    Fig 4: Exhaust Manifold Bolts With Torque Specification (2WD)
    G12230431Courtesy of MAZDA MOTORS CORP.
  7. Tighten the bolt (6) shown in the figure.
  8. Tighten the bolt (7) shown in the figure.
scientia non olet · About LEMON Manuals