Rear Oil Seal Installation Note
WARNING: This page is about a different variant/trim than selected.
- Apply clean engine oil to the inner surface of a new rear oil seal.
- Insert the rear oil seal into the cylinder block by hand.
- Tap the rear oil seal in evenly using the SST and a hammer.
VIN 7
 Courtesy of MAZDA MOTORS CORP.
|
VIN L
 Courtesy of MAZDA MOTORS CORP.
|
 Courtesy of MAZDA MOTORS CORP.
|
Rear oil seal press on amount
0-0.5 mm {0-0.019 in} from edge surface of cylinder block