Exhaust Manifold Bracket No. 1 Installation Note

WARNING: This page is about a different variant/trim than selected.

Temporarily tighten the exhaust manifold bracket No. 1 installation bolts in the order shown in the figure.

Fig 1: Exhaust Manifold Bracket No. 1 Bolts Tightening Sequence
Courtesy of MAZDA MOTORS CORP.
Loosen the bolt shown in the figure until it is no longer seated on the surface.

Courtesy of MAZDA MOTORS CORP.
Tighten the bolts in the order shown in the figure.

Fig 2: Exhaust Manifold Bracket No. 1 Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.