Function Inspection Using M-MDS

WARNING: This page is about a different variant/trim than selected.

DIANOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step	Inspection	Results	Action
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA Is the DTC P3498:00 or P349B:00 on freeze frame data?	Yes	Go to the next step.
2		No	Go to the troubleshooting procedure for DTC on freeze frame data. (See DTC TABLE [PCM (SKYACTIV-G (US))] .)
3	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
4	PURPOSE: INSPECT FOR OTHER RELATED DTCs Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (SKYACTIV-G (US))] .)
4		No	Go to the next step.
5	PURPOSE: VERIFY IF THERE IS PID ITEM CAUSING DRASTIC CHANGES OF ACCELERATION FLUCTUATION BY INPUT SIGNAL TO PCM Start the engine. Access the following PIDs using the MMDS: (See PID/DATA MONITOR INSPECTION .) APP1 APP2 ECT ECT_VOLT IAT MAF MAP MAP_VOLT ENG_RPM TP_RELAT VSS Is there a PID item affected by acceleration fluctuation?	Yes	Inspect the suspected sensor and related wiring harness. If there is any malfunction: Repair or replace the malfunctioning part. Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification. If there is no malfunction: Go to the next step.
5		No	Go to the next step.