i-ACTIVSENSE OFF SWITCH INSPECTION: Notes
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The i-ACTIVSENSE OFF switch is integrated with the cluster switch No. 1.
- For the i-ACTIVSENSE OFF switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Disconnect the cluster switch No. 1 connector. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)
- Attach the tester lead to the cluster switch No. 1 wiring harness-side connector and inspect voltage or continuity according to the Terminal Voltage Table (Reference) on the table.
- If not as specified, repair or replace the related wiring harness.
- If as specified, replace the cluster switch No. 1. (See CLUSTER SWITCH REMOVAL/INSTALLATION .)