360° View Monitor Control Module Inspection
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The integrity of the 360° view monitor control module cannot be determined from a single part. When inspecting the 360° view monitor control module, perform the following procedure.
- Connect the M-MDS to the DLC-2.
- Perform the DTC inspection for the 360° view monitor control module and verify if any DTCs related to the 360° view monitor control module is detected. (See DTC INSPECTION
.)
- If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [360° VIEW MONITOR CONTROL MODULE (US)] .)