No-load Test
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged. (See BATTERY INSPECTION (US) .)
- Connect the starter, battery, and a tester as shown in the illustration.
- Operate the starter and verify that it rotates smoothly.
- If the starter does not rotate smoothly, inspect the starter unit.
- Measure the voltage and current while the starter is operating.
- If not within specification, replace the starter.
[SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))]
11 V
Starter no-load test current
SKYACTIV-G 2.0: 95 A or less
SKYACTIV-G 2.5: 90 A or less