LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (On-Board Diagnostic - Body Control Module (BCM) (3 Of 3)) >> Snapshot Data Table (BCM)

Snapshot Data Table (BCM)

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

-: Not applicable

SNAPSHOT DATA DESCRIPTION (BCM)

Snapshot data item Unit Data contents Corresponding data monitor items
AMB_TEMP °C, °F Ambient temperature AMB_TEMP
APP % Accelerator pedal position status APP
BRK_SW Not Stepping/Stepping Brake pedal position status BRK_SW
ECT °C, °F Engine coolant temperature ECT (1)
ENG_RPM Rpm Engine speed status ENG_RPM(1)
ENG_RUN_TIME Second Elapsed time since engine was started -
F_WASH_CTRL_ALLW Wash_Allowed/Not_Allowed
  • Wash_Allowed: Use of windshield washer is permitted.
  • Not_Allowed: Use of windshield washer is not permitted.
 F_WASH_CTRL_ALLW
F_WASH_SW Off/On Windshield washer switch status F_WASH_SW
F_WIP OFF/Front Wiper On Lo/Front Wiper On Hi/Front Wiper INT Auto On Windshield wiper switch status F_WIP
F_WIP_ANG_SEN_FAIL Not_Failure/Failure
  • Not_Failure: Position sensor in the windshield wiper motor is normal.
  • Failure: Position sensor in the windshield wiper motor has a malfunction.
 F_WIP_ANG_SEN_FAIL
F_WIP_CTRL F.Wiper Off/F.Wiper Lo/F.Wiper Hi
  • F.WiperOff: Windshield wipers are not operated.
  • F.WiperLo: Windshield wipers are operated at low speed.
  • F.WiperHi: Windshield wipers are operated at high speed.
 F_WIP_CTRL
F_WIP_FET_FAIL Not_Failure/Failure
  • Not_Failure: FET circuit is normal.
  • Failure: FET circuit has a malfunction.
 F_WIP_FET_FAIL
F_WIP_INT_VOL % Windshield wiper INT level signal value F_WIP_INT_VOL
F_WIP_POS Unknown/Parking_Position/Not_Parking_Position Windshield wipers position status F_WIP_POS
F_WIP_REG_FAIL Not_Failure/Failure
  • Not_Failure: Windshield wiper regulator is normal.
  • Failure: Windshield wiper regulator is not normal.
 F_WIP_REG_FAIL
F_WIP_REQ Off/Stop (Parking Position)/F.WiperLo/F.WiperHi/Stop (ServicePosition)/Stop (Current Position)
  • Off: Body control module (BCM) does not operate windshield wipers.
  • Stop (Parking Position): Body control module (BCM) operates to the park position.
  • F.WiperLo: Body control module (BCM) operates windshield wipers at low speed.
  • F.WiperHi: Body control module (BCM) operates windshield wipers at high speed.
  • Stop (Service Position): Body control module (BCM) operates to the service position.
  • Stop (Current Position): Body control module (BCM) operates to the current position.
 F_WIP_REQ
F_WIP_ROT_FAIL Not_Failure/Failure
  • Not_Failure: Windshield wiper rotation direction is normal.
  • Failure: Windshield wiper rotation direction is not normal.
 F_WIP_ROT_FAIL
F_WIP_TEACH_STAT_SUB No_Sub_Status/Detect_jig_out_of_area/Unusually_Mode_Switch/DataFlash_Failure/FrontWipr_Failure/Not_detect_jig
  • No_Sub_Status: Body control module (BCM) cannot receive any signal from windshield wiper arm and blade.
  • Detect_jig_out_of_area: Windshield wiper arm and blade movement is detected to be outside of specified range.
  • Unusually_Mode_Switch: Windshield wiper and washer switch is not normal.
  • DataFlash_Failure: Data is not normal.
  • FrontWipr_Failure: Windshield wipers are malfunctioning.
 F_WIP_TEACH_STAT_SUB
F_WIP_THRM_FAIL Not_Failure/Failure
  • Not_Failure: Circuit detecting windshield wiper motor temperature is normal.
  • Failure: Circuit detecting windshield wiper motor temperature is not normal.
 F_WIP_THRM_FAIL
F_WIP_TIME_FAIL Not_Failure/Failure
  • Not_Failure: Windshield wiper is operating normally.
  • Failure: Windshield wiper operating speed is extremely slow (when the Windshield wiper is operating).
 F_WIP_TIME_FAIL
F_WIP_VOLT_FAIL Not_Failure/Failure
  • Not_Failure: Circuit detecting windshield wiper motor voltage is normal.
  • Failure: Circuit detecting windshield wiper motor voltage is normal.
 F_WIP_VOLT_FAIL
GLOBAL_REAL_TIME min Accumulated total elapsed time since vehicle completion until body control module (BCM) detects a DTC GLOBAL_REAL_TIME
IG_ON_TIMER Min Elapsed time since ignition was switched ON (engine off or on) IG_ON_TIMER
POWER_MODE OFF/ACC/ON/CRANK Ignition switch status POWER_MODE
R_WASH_SW Off/On
  • Off: Rear wiper and washer switch is not in rear washer position.
  • On: Rear wiper and washer switch is in rear washer position.
 R_WASH_SW
R_WIP Off/RearWiperLo/Not defined/WiperINT
  • Off: Rear wiper and washer switch is in the OFF position.
  • RearWiperLo: Rear wiper and washer switch is in the ON position.
  • Not defined: Rear wiper and washer switch position is not determined.
  • WiperINT: Rear wiper and washer switch is in the INT position.
 R_WIP
RLS_AMB_TEMP (2) °C, °F Rain sensor ambient temperature RLS_AMB_TEMP
RLS_FAIL_STAT (3) Faulty (Faulty)/Initialize/Not within specifications/Normal (sensing) Auto light sensor condition RLS_FAIL_STAT
RLS_FWD_LGHT_SEN(3) OK/NG
  • OK: Normal forward brightness can be detected.
  • NG: Normal forward brightness cannot be detected.
 RLS_FWD_LGHT_SEN
RLS_I_ILLMI_MODE(3) Unknown/Off (day_mode)/On (night_mode)
  • Unknown: Panel light illumination request signal is not determined.
  • Off (day_mode): Panel light illumination request signal is not received.
  • On (night_mode): Panel light illumination request signal is received.
 RLS_I_ILLMI_MODE
RLS_LGHT_SEN_FAIL(3) Normal/Fault
  • Normal: Error signals is not received from the auto light sensor.
  • Fault: Error signals is received from the auto light sensor.
 RLS_LGHT_SEN_FAIL
RLS_RAIN_SEN_FAIL(2) Off/On
  • Off: Error signals is not received from the rain sensor.
  • On: Error signals is received from the rain sensor.
 RLS_RAIN_SEN_FAIL
RLS_RELAT_HMDTY % Relative humidity RLS_RELAT_HMDTY
RLS_TEMP_SEN_FAIL Normal/Fault
  • Normal: Error signals is not received from the temperature sensor (built into humidity sensor).
  • Fault: Error signals is received from the temperature sensor (built into humidity sensor).
 RLS_TEMP_SEN_FAIL
RLS_UP_LGHT_SEN(3) OK/NG
  • OK: Normal upward brightness can be detected.
  • NG: Normal upward brightness cannot be detected.
 RLS_UP_LGHT_SEN
RLS_VOLT_FAIL (2), (3), or (4) Normal/Fault
  • Normal: Power supply voltage of humidity sensor/solar radiation sensor/auto light sensor/rain sensor is normal.
  • Fault: Power supply voltage of humidity sensor/solar radiation sensor/auto light sensor/rain sensor is not normal.
 RLS_VOLT_FAIL
RLS_WINDOW_TEMP(2) °C, °F Windshield temperature. RLS_WINDOW_TEMP
RLS_WIP_REQ WiperOFF/WiperOff_duringAutoINT/Single Wipe/SpeedLow/SpeedHigh/Failure
  • WiperOFF: Wiper operation signal is not received from rain sensor.
  • WiperOff_duringAutoINT: Error signals is received from the auto light sensor.
  • Single Wipe: Signal to operate wiper once is received from rain sensor.
  • SpeedLow: Signal to operate wiper at low speed is received from rain sensor.
  • SpeedHigh: Signal to operate wiper at high speed is received from rain sensor.
  • Failure: Communication with rain sensor is failed.
 RLS_WIP_REQ
SHIFT_POS Parking/Neutral/Parking/Reverse/Neutral/between 2 position/Forward Drive 1/Forward Drive 2/Forward Drive 3/Forward Drive 4/Forward Drive 5/Forward Drive 6/Forward Drive 7/Forward Drive 8/Invalid Selector lever position status -
TIRE_PRES_L/F kPa Tire pressure (wheel unit (LF)) TIRE_PRES_L/F
TIRE_PRES_L/R kPa Tire pressure (wheel unit (LR)) TIRE_PRES_L/R
TIRE_PRES_R/F kPa Tire pressure (wheel unit (RF)) TIRE_PRES_R/F
TIRE_PRES_R/R kPa Tire pressure (wheel unit (RR)) TIRE_PRES_R/R
TIRE_TEMP_L/F °C, °F Tire temperature (wheel unit (LF)) TIRE_TEMP_L/F
TIRE_TEMP_L/R °C, °F Tire temperature (wheel unit (LR)) TIRE_TEMP_L/R
TIRE_TEMP_R/F °C, °F Tire temperature (wheel unit (RF)) TIRE_TEMP_R/F
TIRE_TEMP_R/R °C, °F Tire temperature (wheel unit (RR)) TIRE_TEMP_R/R
TMTR_LO_VOLT V Remote transmitter voltage -
TOTAL_DIST km, ft, mi Accumulated total traveled distance from completion of vehicle until body control module (BCM) detects a DTC TOTAL_DIST
VPWR_CBCM V Body control module (BCM) power supply voltage VPWR_CBCM
VPWR_LIMP_HOME V Voltage at body control module (BCM) terminal 1B (power supply) VPWR_LIMP_HOME
VSS Kph, Mph Vehicle speed status VSS (1)
(1) PCM PID (See PID/DATA MONITOR TABLE [PCM (SKYACTIV-G (US))] .)

(2) Wiith auto wiper system

(3) Wiith auto light system

(4) Wiith solar radiation sensor
scientia non olet · About LEMON Manuals