LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical System (VIN L)) >> Front Oil Seal Replacement >> Crankshaft Pulley Lock Bolt Installation Note

Crankshaft Pulley Lock Bolt Installation Note

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • To prevent damage to the crankshaft pulley, protect the crankshaft pulley with a clean cloth so that the bar part (205-072) of the SST does not contact the crankshaft pulley.
  • To prevent damage to the engine front cover, be careful not to allow the tab part (49 B011 105) of the SST to get caught between the crankshaft pulley and the engine front cover.
  1. Hold the crankshaft pulley using the SSTs.
    G11436721Courtesy of MAZDA MOTORS CORP.
  2. Tighten the crankshaft pulley lock bolt in the order shown in the following two steps.
scientia non olet · About LEMON Manuals