PID/DATA Monitor Inspection
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Verify that the clutch pedal position (PID: CLTCH_PEDAL_POS) input from the clutch stroke sensor is within the standard when the clutch pedal is depressed. (See PID/DATA MONITOR INSPECTION
.)
- If not within the specification, replace the clutch master cylinder. (See appropriate service information.)