PID/Data Monitor Table

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

-: Not applicable

PID

Unit/Operation

Data contents

Module control terminal

AUTO_HOLD_IND

Off/On

Off: AUTOHOLD stand-by indicator light turns off.
On: AUTOHOLD stand-by indicator light turns on.

AUTO_HOLD_SW

Off/On

Off: AUTOHOLD switch is off.
On: AUTOHOLD switch is on.

B2_VOLT

Displays voltage at electrical supply unit (ESU) terminal 5C (power supply)

B7_VOLT

Displays voltage at electrical supply unit (ESU) terminal 4H (power supply)

BACK_UP_VOLT

Displays intermediate voltage of back-up power supply.

BGLR_HORN

Off/On

Off: Theft-deterrent horn is not operated.
On: Theft-deterrent horn is operated.

BRK_SW

Off/On

Off: Brake switch (No. 1 signal) is off.
On: Brake switch (No. 1 signal) is on.

CARGO_LAMP_STAT

OFF/ON/Fail (Circuit Short to GND)

OFF: Cargo compartment light does not illuminate.
ON: Cargo compartment light illuminates.
Fail (Circuit Short to GND): Short to ground in cargo compartment light circuit is detected.

CARGO_SW

Close/Open

Close: Liftgate is close.
Open: Liftgate is open.

CLOSED_FUEL_TANK

Off/On

OFF: Sealed tank is not equipped.
ON: Sealed tank is equipped.

3C, 3A, 1W, 1X

COUPLING_TEMP_SEN

°C, °F

Displays oil temperature of coupling component.

1E, 1G

DOOR_SW_L/F

Close/Open

Close: Front door (LH) is closed.
Open: Front door (LH) is open.

DOOR_SW_L/R

Close/Open

Close: Rear door (LH) is closed.
Open: Rear door (LH) is open.

E_LATCH_MOTOR⁽¹⁾

Not Drive/Drive

Not Drive: Liftgate latch and lock actuator is not operated.
Drive: Liftgate latch and lock actuator is operated.

FUEL_LID_MOTOR_L

Off/On

OFF: Fuel-filler lid lock actuator is not operated to lock.
ON: Fuel-filler lid lock actuator is operated to lock.

FUEL_LID_MOTOR_STAT

Not Drive/Lock/UnLock

Not Drive: Fuel-filler lid lock actuator motor is not operated.
Lock: Fuel-filler lid lock actuator motor perform a lock operation.
UnLock: Fuel-filler lid lock actuator motor perform a unlock operation.

FUEL_LID_MOTOR_UL

Off/On

OFF: Fuel-filler lid lock actuator is not operated to unlock.
ON: Fuel-filler lid lock actuator is operated to unlock.

FUEL_LID_SW

NOTE:

Displays in the M-MDS but it does not operate.

FUEL_LID_LCK_REQ

Not Drive/Lock/UnLock

Not Drive: All door lock signal and all door unlock signal are not received.
Lock: All door lock signal is received.
UnLock: All door unlock signal is not received.

3C, 3A, 1W, 1X

FUEL_LID_ULCK_REQ

Off/On

OFF: All door unlock signal is not received.
ON: All door unlock signal is received.

3C, 3A, 1W, 1X

FUEL_SEN_MAIN_GAUGE

Displays the fuel gauge

1J, 1F

FUEL_SEN_SUB_GAUGE

Displays the fuel gauge (sub)

1J, 1F

FUEL_SEN_VOLT

Fuel gauge sender unit voltage

5P, 5C

IG1_VOLT

Displays voltage at electrical supply unit (ESU) terminal 5K (ignition power supply)

LID_STOP_LAMP

Off/On

Off: Liftgate light is turned off.
On: Liftgate light is turned on.

OIL_TEMP_SEN

°C, °F

Displays rear differential oil temperature.

1I, 1K

PARK_BRK_SW

NOTE:

Displays in the M-MDS but it does not operate.

R_FOG_REQ

NOTE:

Displays in the M-MDS but it does not operate.

R_FOG_STAT

NOTE:

Displays in the M-MDS but it does not operate.

R_TURN_STAT_L

Off/On

Off: Rear turn light (LH) is turned off.
On: Rear turn light (LH) is turned on.

R_TURN_STAT_R

Off/On

Off: Rear turn light (RH) is turned off.
On: Rear turn light (RH) is turned on.

R_WIP_AUTO_STOP_SW

Parking Pos/Not Parking Pos

Parking Pos: Auto stop switch is on.
Not Parking Pos: Auto stop switch is off.

R_WIP_STAT

Off/On

Off: Rear wiper is not operated.
On: Rear wiper is operated.

REV_LAMP_CTRL_STAT

Off/On/Unknown/Fault

Off: Back-up light on signal is not sent from electrical supply unit (ESU).
On: Back-up light on signal is sent from electrical supply unit (ESU).
Unknown: Back-up light on signal is not determined.
Fault: Error signals is received from body control module (BCM).

3C, 3A, 1W, 1X

REV_LAMP_STAT

Off/On

Off: Back-up lights are not illuminated.
On: Back-up lights are illuminated.

S_BELT_STAT_C/R

Not insert/Insert

Not insert: Rear center buckle switch is on.
Insert: Rear center buckle switch is off.

S_BELT_STAT_L/3RD

NOTE:

Displays in the M-MDS but it does not operate.

S_BELT_STAT_L/R

Not insert/Insert

Not insert: Rear buckle switch (LH) is on.
Insert: Rear buckle switch (LH) is off.

S_BELT_STAT_R/3RD

NOTE:

Displays in the M-MDS but it does not operate.

S_BELT_STAT_R/R

Not insert/Insert

Not insert: Rear buckle switch (RH) is on.
Insert: Rear buckle switch (RH) is off.

SEAT_SEN_C/3RD

NOTE:

Displays in the M-MDS but it does not operate.

SEAT_SEN_C/R

NOTE:

Displays in the M-MDS but it does not operate.

SEAT_SEN_L/3RD

NOTE:

Displays in the M-MDS but it does not operate.

SEAT_SEN_L/R

NOTE:

Displays in the M-MDS but it does not operate.

SEAT_SEN_R/3RD

NOTE:

Displays in the M-MDS but it does not operate.

SEAT_SEN_R/R

NOTE:

Displays in the M-MDS but it does not operate.

SOL_CUR

Displays the current of the AWD solenoid.

2B, 2C

STOP_LAMP_STAT

Off/On

Off: High-mount brake light is turned off.
On: High-mount brake light is turned on.

5B, 3B

T/LGT_REQ

Off/On

OFF: Liftgate release signal is not received.
ON: Liftgate release signal is received.

3C, 3A, 1W, 1X

TAIL_LAMP_STAT

Off/On

Off: Taillights are not illuminated.
On: Taillights are illuminated.

TNS_LAMP_STAT

Off/On

Off: TNS (parking lights) is turned off.
On: TNS (parking lights) is turned on.

TOWBAR_SW

Off/On

NOTE:

It is displayed, however, if an accessory part is installed, it cannot be used.

TOWING_SW

Off/On

NOTE:

It is displayed, however, if an accessory part is installed, it cannot be used.

VPWR

Displays voltage at electrical supply unit (ESU) terminal 5P (power supply)

⁽¹⁾	Without power liftgate (PLG) system