Boot Band Assembly Note
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the boot band to the boot.
- Crimp the boot band using the SST.
- Verify that crimp A of the boot band is within the standard.
Standard
1.5-2.0 mm {0.06-0.08 in}
- If crimp A exceeds the standard, decrease the opening width of the SST and crimp the boot band again.
- If width A of the crimp is less than the standard, increase the opening width of the SST and crimp a new boot band.
- Rotate the boot by hand and verify that the boot is securely installed by the boot band.