Diagnostic Procedure
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | INSPECT ABS WHEEL-SPEED SENSOR (LF) FOR MALFUNCTION DEPENDING ON REPEATABILITY
|
Yes | Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, replace the malfunctioning location and perform the repair completion verification. (See FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION (US) .) |
| No | Go to repair completion verification 2. | ||
| Repair completion verification 1 | VERIFY THAT VEHICLE IS REPAIRED
|
Yes | Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, perform the diagnosis from Step 1.
(See DSC HU/CM REMOVAL/INSTALLATION [L.H.D. (US)] .) |
| No | Go to the next step. | ||
| Repair completion verification 2 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning location according to the applicable DTC troubleshooting. |
| No | DTC troubleshooting completed. |