DTC C0061-54, C0062-54 Or C0063-54: DSC HU/Cm System (Unperformed Initialization Procedure) [DSC HU/Cm]: Outline
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
| System malfunction location |
DSC HU/CM system (unperformed initialization procedure) |
| Detection condition |
NOTE:
- The low-G sensor and the yaw rate sensor are built into the Sophisticated Airbag Sensor (SAS) control module.
- C0061:54
- The DSC HU/CM detects that the lateral-G sensor value initialization was not implemented.
- C0062:54
- The DSC HU/CM detects that the longitudinal-G sensor value initialization was not implemented.
- C0063:54
- The DSC HU/CM detects that the yaw rate sensor value initialization was not implemented.
|
| Fail-safe |
Refer to "DTC Table" and "Fail-safe Function Malfunction Contents Table". (See DTC TABLE [DSC HU/CM (US)] .) |
| Possible cause |
- The initialization procedure for the lateral acceleration sensor has not been performed.
- The initialization procedure for the longitudinal acceleration sensor has not been performed.
- The initialization procedure for the yaw rate sensor has not been performed.
- Sophisticated Airbag Sensor (SAS) control module malfunction
- Low-G sensor malfunction
- Yaw rate sensor malfunction
|
| System wiring diagram |
Not applicable |
| Connector diagram |
Not applicable |