LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (On-Board Diagnostics - Automatic Transaxle System (ET6A-El, ET6AX-El)) >> DTC P2855-00: Low Clutch Hydraulic Circuit/Sealing Malfunction (TCM) (Us) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2855:00 (TCM, ET6A-EL, ET6AX-EL, US) DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 INSPECT ATF LEVEL
 Yes Adjust the ATF level to the specification, then go to repair completion verification.
(See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [ET6A-EL, ET6AX-EL (US)] .)
No Replace the automatic transaxle.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (SKYACTIV-G 2.0, SKYACTIV-G 2.5) (US)] .)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (SKYACTIV-G 2.0, SKYACTIV-G 2.5 (US))] .)
Repair completion verification VERIFY DTC TROUBLESHOOTING COMPLETED
  • Perform the following procedure to ensure that the DTC has been resolved:
  1. Verify that the ATF temperature is 30°C {86°F} or more.
  2. Perform the following operation 20 times.
  • Operate the selector lever from N to D position and wait for 5 s or more.
    • Operate the selector lever from D to N position and wait for 5 s or more.
  • Perform the DTC inspection using the M-MDS. (See DTC INSPECTION .)
  • Is the same Pending DTC present?
 Yes Replace the automatic transaxle.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6A-EL (SKYACTIV-G 2.0, SKYACTIV-G 2.5) (US)] .)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [ET6AX-EL (SKYACTIV-G 2.0, SKYACTIV-G 2.5 (US))] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals