DTC P0717-00: Open Circuit In Turbine/Input Shaft Speed Sensor Circuit (TCM) (Us): Outline

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0717:00 (TCM, ET6A-EL, ET6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Open circuit in turbine/input shaft speed sensor circuit
Detection condition	Under the following conditions, the turbine/input shaft speed sensor signal is not input for 1 s: Engine is running. Vehicle speed signal related DTC is not recorded. Vehicle speed is 16 km/h {9.9 mph} or more. There is no correlation between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal. DTC U0121:00 is not recorded.
Fail-safe	Set to TCC control. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS. Inhibits 5GR and 6GR. Inhibits shift down when the accelerator pedal is depressed.
Possible cause	Turbine/input shaft speed sensor malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable