Active Driving Display Inspection

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

After switching the ignition ON (engine off), switch the light switch within 5 s as follows.
- OFF → TNS (parking lights) → OFF → TNS (parking lights) → OFF → TNS (parking lights) → OFF
Switch the light switch (dimmer switch) within 5 s after Step 1 as follows.
- OFF → Headlight HI ON → OFF → Headlight HI ON → OFF → Headlight HI ON → OFF

Verify that the display screen of the active driving display changes each time the light switch is switched between OFF and TNS (parking lights).

Number of times light switch is switched between OFF and TNS (parking lights)	Display screen
-	Courtesy of MAZDA MOTORS CORP.
1 time	Courtesy of MAZDA MOTORS CORP.
2 times	Courtesy of MAZDA MOTORS CORP.
3 times	Courtesy of MAZDA MOTORS CORP.
4 times	Courtesy of MAZDA MOTORS CORP.
5 times	Courtesy of MAZDA MOTORS CORP.
6 times	Courtesy of MAZDA MOTORS CORP.
7 times	Courtesy of MAZDA MOTORS CORP.
8 times	Courtesy of MAZDA MOTORS CORP.
9 times	Courtesy of MAZDA MOTORS CORP.

If the display screen for the active driving display cannot be changed, refer to the symptom troubleshooting. (See SYMPTOM TROUBLESHOOTING [ACTIVE DRIVING DISPLAY] .)