Diagnostic Procedure

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

NO CREEP AT ALL (EV6A-EL, EV6AX-EL) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	INSPECT ENGINE CONTROL SYSTEM FOR MALFUNCTION Perform the symptom troubleshooting "LOW IDLE/STALLS DURING DECELERATION". (See LOW IDLE/STALLS DURING DECELERATION [SKYACTIV-G (US)] .) Is there any malfunction?	Yes	Repair or replace any malfunctioning parts according to the inspection result.
1		No	Go to the next step.
2	VERIFY IF MALFUNCTION CAUSE IS TORQUE CONVERTER Is the malfunction symptom at same level compared to a vehicle of the same model?	Yes	Symptom troubleshooting is completed.
2		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [EV6A-EL (US)] .) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [EV6AX-EL (US)] .)