Coil resistance inspection
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
- Disconnect the OCV for hydraulic variable valve timing system connector.
- Measure the resistance between terminals A and B using an ohmmeter.
OCV for hydraulic variable valve timing system coil resistance
6.9-7.5 ohms [20°C {68°F}]
- If not as specified, replace the OCV for hydraulic variable valve timing system. (See OCV FOR HYDRAULIC VARIABLE VALVE TIMING SYSTEM REMOVAL/INSTALLATION .)
- Install in the reverse order of removal.