Power Liftgate (PLG) Rear Switch Inspection
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal.
- Remover the power liftgate (PLG) rear switch. (See POWER LIFTGATE (PLG) REAR SWITCH REMOVAL/INSTALLATION .)
- Verify that the continuity between the power liftgate (PLG) rear switch terminals is as indicated in the table.
- If not as indicated in the table, replace the power liftgate (PLG) rear switch. (See POWER LIFTGATE (PLG) REAR SWITCH REMOVAL/INSTALLATION .)
- Apply battery voltage to power liftgate (PLG) rear switch terminal A, and connect terminal B to ground.
- Verify that the LED illuminates.
- If there is any malfunction, replace the power liftgate (PLG) rear switch. (See POWER LIFTGATE (PLG) REAR SWITCH REMOVAL/INSTALLATION .)