Power Liftgate (PLG) Drive Unit Inspection: RH
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal.
- Remove the power liftgate (PLG) drive unit. (See POWER LIFTGATE (PLG) DRIVE UNIT REMOVAL/INSTALLATION .)
- Apply battery positive voltage and connect the ground to power liftgate (PLG) drive unit terminals G and H, and then inspect the power liftgate (PLG) drive unit operation.
B+ Terminal Ground Terminal Operation H F Liftgate close operation G F Liftgate open operation - If the power liftgate (PLG) drive unit does not operate as indicated in the table, replace it. (See POWER LIFTGATE (PLG) DRIVE UNIT REMOVAL/INSTALLATION .)