ALR (Automatic Locking Retractor)
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Pull the belt out fully to change the lock mode from ELR to ALR.
- Verify that the retractor makes a clicking sound as the belt slowly retracts. If no sound is heard, the lock mode has not changed to ALR. If necessary, repeat Step 1.
- If there is any malfunction, replace the seat belt. (See FRONT SEAT BELT REMOVAL/INSTALLATION .) (See REAR SEAT BELT REMOVAL/INSTALLATION (US) .) (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION .)
- Verify that the retractor locks when pulled.
- If there is any malfunction, replace the seat belt. (See FRONT SEAT BELT REMOVAL/INSTALLATION .) (See REAR SEAT BELT REMOVAL/INSTALLATION (US) .) (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION .)
- Verify that the lock mode changes to ELR when the belt is fully pulled out.
- If there is any malfunction, replace the seat belt. (See FRONT SEAT BELT REMOVAL/INSTALLATION .) (See REAR SEAT BELT REMOVAL/INSTALLATION (US) .) (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION .)