Rotating only front or rear wheels
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- If only the front or rear wheels are rotated, the DSC HU/CM will determine that the DSC is malfunctioning. It will also determine that the vehicle control module is malfunctioning and the following warning indication/warning light will be indicated.
- i-ACTIVSENSE warning indication/warning light is indicated
- Master warning indication
- If the warning indication/warning light is indicated, remove the vehicle from the chassis dynamometer and switch the ignition off.
- Switch the ignition back ON and drive the vehicle at10 km/h {6.2 mph} or more to verify that the warning light turns off.
- Because DTCs are stored, clear DTCs according to the memory clearing procedure.