After road test

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

The following items must be completed just before delivery to your customer.

Tire pressures (See tire label located on driver's side B-pillar or edge driver's of door frame for specification.)

Initialize the TPMS*. Switch the ignition ON, then press and hold TPMS SET switch until the TPMS warning light and one beep flashes twice is heard.

NOTE:

Only when the condition TPMS initialization required. Refer to the Work Shop service information.

Tire pressure record
Left front	Right front	Left rear	Right rear	Spare

Indicated that long-pressing of the tire pressure monitoring system set switch was implemented
Yes or No

After washing and drying the vehicle, perform appearance checks before delivery

APPEARANCE CHECKS BEFORE DELIVERY
In addition to function checks, also perform one last inspection of key areas of the vehicle to ensure they are clean and free of chips and scratches.
Check and repair chips and scratches:	Remove dirt and Scratches from key areas:
Door edges Around door handles Door dings and dents Hood leading edges Bumper covers	Door sill scuff plates Door inner panel Seats Carpets and floor mats Steering wheel Center console