LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (On-Board Diagnostic - Dash-Electrical Supply Unit) >> PID/Data Monitor Table [Dash-Electrical Supply Unit (Us)]

PID/Data Monitor Table [Dash-Electrical Supply Unit (Us)]

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

-: Not applicable

PID/DATA MONITOR REFERENCE [DASH-ELECTRICAL SUPPLY UNIT (US)]

PID Unit/Operation Data contents Module control terminal
AIR_MIX_L - Displays the target actuator opening angle of the air mix actuator (LH). 2B
AIR_MIX_MODE_L Stopped/AirMix LH Actuator Max Cold Position/AirMix LH Actuator Max Hot Position/AirMix LH Actuator Half Position
  • Stopped: Air mix actuator (LH) is stopped
  • AirMix LH Actuator Max Cold Position: Air mix actuator (LH) is operating so that air mix door position is at MAX COLD control
  • AirMix LH Actuator Max Hot Position: Air mix actuator (LH) is operating so that air mix door position is at MAX HOT control
  • AirMix LH Actuator Half Position: Air mix actuator (LH) is operating so that air mix door position is at middle position of MAX COLD control and MAX HOT control
 2B
AIR_MIX_MODE_R Stopped/AirMix RH Actuator Max Cold Position/AirMix RH Actuator Max Hot Position/AirMix RH Actuator Half Position
  • Stopped: Air mix actuator (RH) is stopped
  • AirMix RH Actuator Max Cold Position: Air mix actuator (RH) is operating so that air mix door position is at MAX COLD control
  • AirMix RH Actuator Max Hot Position: Air mix actuator (RH) is operating so that air mix door position is at MAX HOT control
  • AirMix RH Actuator Half Position: Air mix actuator (RH) is operating so that air mix door position is at middle position of MAX COLD control and MAX HOT control
 2B
AIR_MIX_POS_L - Displays the actuator opening angle (feedback value) of the air mix actuator (LH). 2B
AIR_MIX_POS_R - Displays the actuator opening angle (feedback value) of the air mix actuator (RH). 2B
AIR_MIX_R - Displays the target actuator opening angle of the air mix actuator (RH). 2B
AMB_TEMP °C, °F Displays the ambient temperature detected by the ambient temperature sensor. -
AMB_TEMP_INTERNAL °C, °F Displays the cabin temperature detected by the passenger compartment temperature sensor. -
BLOWER_MOTOR_RLY OFF/ON
  • OFF: Blower relay is off
  • ON: Blower relay is on
 -
ECT °C, °F Displays the engine coolant temperature detected by the ECT sensor. -
EVA_TEMP °C, °F Displays the evaporator temperature detected by the evaporator temperature sensor. 2E
FOOT_LAMP OFF/ON
NOTE:
  • It is displayed, however, if an accessory part is installed, it cannot be used.
 1A
HEAT_CORE_TEMP °C, °F Heater core temperature is displayed. -
ILLMI_STAT OFF/ON
NOTE:
  • Displays in the M-MDS but it does not operate.
 -
INTAKE_ACTAT - Displays the target actuator opening angle of the air intake actuator. 2B
INTAKE_ACTAT_MODE Stopped/Intake Actuator Fresh Position/Intake Actuator Recirculation Position/Intake Actuator 25% Rec Position/Intake Actuator 50% Rec Position/Intake Actuator 75% Rec Position
  • Stopped: Air intake actuator is stopped
  • Intake Actuator Fresh Position: Intake actuator is operating so that intake door position is at FRESH 100%
  • Intake Actuator Recirculation Position: Intake actuator is operating so that intake door position is at REC 100%
  • Intake Actuator 25% Rec Position: Intake actuator is operating so that intake door position is at REC 25%/FRESH 75%
  • Intake Actuator 50% Rec Position: Intake actuator is operating so that intake door position is at REC 50%/FRESH 50%
  • Intake Actuator 75% Rec Position: Intake actuator is operating so that intake door position is at REC 75%/FRESH 25%
 2B
INTAKE_ACTAT_POS - Displays the actuator opening angle (feedback value) of the air intake actuator. 2B
LIFT_DOWN_SW OFF/ON
  • Off: Lift switch is not in down
  • On: Lift switch is in down
 3J
LIFT_UP_SW OFF/ON
  • Off: Lift switch is not in up
  • On: Lift switch is in up
 3J
MEMORY_SEAT_LIFT Stop/Moving Upward/Moving Downward
  • Stop: Lift motor is stopped and front seat height is not adjusted upward and downward
  • Moving Upward: Lift motor adjusts front seat height upward
  • Moving Downward: Lift motor adjusts front seat height downward
 3J
MEMORY_SEAT_RECLINE Stop/Moving Forward/Moving Backward
  • Stop: Recliner motor is stopped and angle of front seat back is not adjusted forward and rearward
  • Moving Forward: Recliner motor adjusts angle of front seat back forward
  • Moving Backward: Recliner motor adjusts angle of front seat back rearward
 3J
MEMORY_SEAT_SLIDE Stop/Moving Forward/Moving Backward
  • Stop: Slide motor is stopped and front and back positions of front seat are not adjusted forward and rearward
  • Moving Forward: Slide motor adjusts front and back positions of front seat forward
  • Moving Backward: Slide motor adjusts front and back positions of front seat rearward
 3J
MEMORY_SEAT_TILT Stop/Moving Upward/Moving Downward
  • Stop: Tilt motor is stopped and height of front seat cushion front side is not adjusted upward and downward
  • Moving Upward: Tilt motor adjusts height of front seat cushion front side upward
  • Moving Downward: Tilt motor adjusts height of front seat cushion front side downward
 3J
MODE_ACTAT - Displays the target actuator opening angle of the airflow mode actuator. 2B
MODE_ACTAT_MODE Stopped/Mode Actuator Vent Position/Mode Actuator Bi-Level Position/Mode Actuator Heat Position/Mode Actuator Def-Heat Position/Mode Actuator Defroster Position
  • Stopped: Airflow mode actuator is stopped
  • Mode Actuator Vent Position: Airflow mode actuator is operating so that mode door position is at VENT
  • Mode Actuator Bi-Level Position: Airflow mode actuator is operating so that mode door position is at Bi-Level
  • Mode Actuator Heat Position: Airflow mode actuator is operating so that mode door position is at HEAT
  • Mode Actuator Def-Heat Position: Airflow mode actuator is operating so that mode door position is at DEF/HEAT
  • Mode Actuator Defroster Position: Airflow mode actuator is operating so that mode door position is at DEFROSTER
 2B
MODE_ACTAT_POS - Displays the actuator opening angle (feedback value) of the airflow mode actuator. 2B
POWER_SEAT_MOTOR_VOLT V Displays the power supply voltage (+B_PS) to the position memory control module 3J
R_VENT_ACTAT - Displays the target actuator opening angle of the rear vent actuator. 2A
R_VENT_ACTAT_MODE Stopped/Rear Vent Actuator Vent Position/Rear Vent Actuator Heat Position/Rear Vent Actuator Defroster Position
  • Stopped: Rear vent actuator is stopped
  • Rear Vent Actuator Vent Position: Rear vent actuator is operating so that rear vent door position is at VENT
  • Rear Vent Actuator Heat Position: Rear vent actuator is operating so that rear vent door position is at HEAT
  • Rear Vent Actuator Defroster Position: Rear vent actuator is operating so that rear vent door position is at DEFROSTER
 2A
R_VENT_ACTAT_POS - Displays the actuator opening angle (feedback value) of the rear vent actuator. 2A
RECLINE_BACK_SW OFF/ON
  • Off: Recliner switch is not in backward
  • On: Recliner switch is in backward
 3J
RECLINE_FWD_SW OFF/ON
  • Off: Recliner switch is not in forward
  • On: Recliner switch is in forward
 3J
S_BELT_STAT Not Buckled/Buckled
  • Not Buckled: Driver-side front seat belt not fastened (Driver-side buckle switch on)
  • Buckled: Driver-side front seat belt fastened (Driver-side buckle switch off)
 3H
SEAT_HEAT_VOLT_F V Displays the power supply voltage (+B_SH1, +B_SH2) to the seat warmer control unit. 3J
SEAT_UNIT_VOLT V Displays the power supply voltage (IG1) to the position memory control module/seat warmer control unit. 3J
SLIDE_BACK_SW OFF/ON
  • Off: Slide switch is not in backward
  • On: Slide switch is in backward
 3J
SLIDE_FWD_SW OFF/ON
  • Off: Slide switch is not in forward
  • On: Slide switch is in forward
 3J
SOLAR_SEN_L W/m 2 Displays the sunlight intensity on the left side of the windshield detected by the solar radiation sensor. -
SOLAR_SEN_R W/m 2 Displays the sunlight intensity on the right side of the windshield detected by the solar radiation sensor. -
STOP_START_STAT Stop Available/Stop Not Available
NOTE:
  • Displays in the M-MDS but it does not operate.
 -
TILT_DOWN_SW OFF/ON
  • Off: Tilt switch is not in down
  • On: Tilt switch is in down
 3J
TILT_UP_SW OFF/ON
  • Off: Tilt switch is not in up
  • On: Tilt switch is in up
 3J
VPWR V Displays the power supply voltage to the dash-electrical supply unit. -
scientia non olet · About LEMON Manuals