LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (On-Board Diagnostic - Dash-Electrical Supply Unit) >> DTC U2300-55: Configuration Data [Dash-Electrical Supply Unit] >> Outline

DTC U2300-55: Configuration Data [Dash-Electrical Supply Unit]: Outline

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
DTC U2300:55 [DASH-ELECTRICAL SUPPLY UNIT] DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location Configuration data
Detection condition
  • The dash-electrical supply unit receives a signal that the body control module (BCM) configuration was not performed.
Fail-safe
  • Not applicable
Possible cause
NOTE:
  • To correctly write the configuration data sent from the body control module (BCM) to dash-electrical supply unit, 30 s or more have to be elapsed since the ignition is switched ON (engine off or on).
  • DTCs are stored in the body control module (BCM).
  • Body control module (BCM) configuration not implemented
    • Body control module (BCM) internal memory malfunction
  • Configuration procedure was not completed properly.
  • Dash-electrical supply unit removed from other vehicle is being used
  • Dash-electrical supply unit malfunction
System wiring diagram Not applicable
Connector diagram Not applicable