Diagnostic Procedure
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1520:54 [DASH-ELECTRICAL SUPPLY UNIT] DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | INSPECT FOR OTHER RELATED DTCs
|
Yes | Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [DASH-ELECTRICAL SUPPLY UNIT (US)] .) |
| No | Go to the next step. | ||
| 2 | IMPLEMENT SEAT POSITION INITIAL LEARNING OF POSITION MEMORY SYSTEM
|
Yes | Repair or replace the malfunctioning location and perform the repair completion verification. (See POSITION MEMORY CONTROL MODULE REMOVAL/INSTALLATION (US) .) |
| No | Go to repair completion verification 2. | ||
| Repair completion verification 1 | VERIFY THAT VEHICLE IS REPAIRED
|
Yes | Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, perform the diagnosis from Step 1.
|
| No | Go to the next step. | ||
| Repair completion verification 2 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning location according to the applicable DTC troubleshooting. |
| No | DTC troubleshooting completed. |