LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (On-Board Diagnostic - Telematics Communication Unit) >> PID/Data Monitor Table

PID/Data Monitor Table

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

-: Not applicable

PID/DATA MONITOR REFERENCE (TELEMATICS COMMUNICATION UNIT)

PID Unit/Operation Data contents Module control terminal
ALRM_NOTIFIC OFF/ON
  • OFF: Alarm notification setting is off.
  • ON: Alarm notification setting is on.
 -
CELLULAR_ACCOUNT OFF/ON
  • OFF: Usable phone number is not registered.
  • ON: Usable phone number is registered.
 -
DIGITAL_NETWORK_NUM - Displays telematics communication unit phone number -
FOTA_PROGRESS % Reads out during FOTA execution, and displays rate of FOTA implementation progress. -
GNSS_ALTITUDE m Displays sea level altitude received from GNSS 2B
GNSS_GALILEO_NUM - Displays number of all Galileo satellites receiving position information -
GNSS_GLONASS_NUM - Displays number of all GLONASS satellites receiving position information -
GNSS_GPS_NUM - Displays number of all GPS satellites receiving position information -
GNSS_HEADING ° (deg) Displays vehicle angle received from GNSS (Based on magnetic north). -
GNSS_LATITUDE milliarcseconds Displays altitude received from GNSS -
GNSS_LONGITUDE milliarcseconds Displays longitude received from GNSS -
GNSS_STAT No fix/2D fix/3D fix/Antenna not properly connected
  • No fix: Position information is not received from GNSS.
  • 2D fix: 2D position information is received from GNSS.
  • 3D fix: 3D position information is received from GNSS.
  • Antenna not properly connected: An antenna is not connected appropriately
 -
GNSS_UTC sec Displays coordinated universal time -
GNSS_VELOCITY km/h Displays vehicle speed detected from GNSS -
IG_STAT OFF/ON
  • OFF: IG1 power supply voltage is low.
  • ON: IG1 power supply voltage is high.
 1AE
IMEI - Displays telematics communication unit identification number -
IMSI - Displays stored IMSI No. -
LOCATION_INFO OFF/ON
  • OFF: Location information setting is off.
  • ON: Location information setting is on.
 -
MAINT_ASSIST OFF/ON
  • OFF: Vehicle health report setting is off.
  • ON: Vehicle health report setting is on.
 -
OPERAT_FORGOTTEN OFF/ON
  • OFF: Vehicle status alert setting is off.
  • ON: Vehicle status alert setting is on.
 -
OPERAT_MONITOR OFF/ON
  • OFF: Operation monitoring service is not usable.
  • ON: Operation monitoring service is usable.
 -
POWER_MODE OFF/ACC/ON/CRANK
  • OFF: Body control module (BCM) controls ignition switch off (lock).
  • ACC: Body control module (BCM) controls ignition switch ACC.
  • ON: Body control module (BCM) controls ignition switch ON (engine off).
  • CRANK: Body control module (BCM) controls cranking at ignition switch ON.
 -
RECALL_NOTIFIC OFF/ON
  • OFF: Recall notification setting is off.
  • ON: Recall notification setting is on.
 -
REMOTE_CHECK OFF/ON
  • OFF: Remote check setting is off.
  • ON: Remote check setting is on.
 -
REMOTE_CTRL OFF/ON
  • OFF: Remote control setting is off.
  • ON: Remote control setting is on.
 -
REMOTE_DIAG_RECORD OFF/ON
  • OFF: Malfunction notification setting is off.
  • ON: Malfunction notification setting is on.
 -
REMOTE_SERVICE OFF/ON/None
  • OFF: Remote service is not contracted.
  • ON: Remote service is contracted.
  • None: Contract of remote service is failed.
 -
REMOTE_WRNG OFF/ON
  • OFF: Remote security alert setting is off.
  • ON: Remote security alert setting is on.
 -
RESULT_CALL_HIST Complete/Fail/Intermit/Emergency Call/No Member Registration Displays final results of call -
SET_DATE date Displays set date for upload file used by connected service function -
SET_HOUR hour Displays set GMT time for upload file used by connected service function -
SET_MINUTE minutes Displays set GMT minutes for upload file used by connected service function -
SET_MONTH month Displays set GMT month for upload file used by connected service function -
SET_SECOND seconds Displays set GMT seconds for upload file used by connected service function -
SET_YEAR year Displays set year for upload file used by connected service function as 2 digits (00) for year 2000 -
SIM_INFO - Displays specific number attached to SIM card -
SOFT_NUM - Displays software version of NAD (communication module) in telematics communication unit -
SUMMER_TIME Off/On
  • Off: Daylight savings time is not detected
  • On: Daylight savings time is detected
 -
TCU_FLAG OFF/ON/Fail
  • OFF: Telematics communication unit is not contracted.
  • ON: Telematics communication unit is contracted.
  • Fail: Contract of telematics communication unit is failed.
 -
TEL_NUM_FLAG OFF/ON/Invalid/Fail
  • OFF: Phone number is not written.
  • ON: Phone number is written.
  • Invalid: Phone number is written but invalid.
  • fail: Failed to write the phone number.
 -
TEL1_ANT_3LVL - Displays radio field strength of TEL antenna in 3 steps -
TEL2_ANT_3LVL - Displays radio field strength of TEL antenna (sub) in 3 steps -
TIME_DIF_RATE Minus/Plus
  • Minus: Local time delayed more than GMT time.
  • Plus: Local time advanced more than GMT time.
 -
TIME_DIF_VALUE Hour Displays time difference relative to GMT time -
TIME_SOURCE CMU/TCU
  • CMU: Time specified by information from connectivity master unit (CMU)
  • TCU: Time specified by telematics communication unit in dependently (including when it is not specified)
 -
TRIGGER_TYPE_HIST Automatic/Manual)
  • Automatic: Records call history automatically.
  • Manual: Records call history manually.
 -
VPWR V Displays voltage at telematics communication unit (power supply) -
scientia non olet · About LEMON Manuals