Upper Face Removal/Installation

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Detach the hood latch protector tabs from the hood latch and remove the hood latch protector.

Courtesy of MAZDA MOTORS CORP.
Open the engine cover. (SKYACTIV-X 2. 0)
Remove the bolts and screws.

Fig 1: Upper Face, Bolts And Screws With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the fasteners A and B.

Courtesy of MAZDA MOTORS CORP.
To prevent scratches or damage, apply protective tape to the positions shown in the illustration.

Courtesy of MAZDA MOTORS CORP.
Detach the upper face from the front bumper slider No. 2.

Courtesy of MAZDA MOTORS CORP.
Move the upper fascia in the direction of arrow (1) shown in the illustration and detach the clips from the front bumper.

Courtesy of MAZDA MOTORS CORP.
Remove the upper fascia in the direction of arrow (2) shown in the illustration.
Install in the reverse order of removal.