LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (On-Board Diagnostics - Automatic Transaxle System (EV6A-El, EV6AX-El)) >> DTC P0707-00: Transaxle Range Sensor Circuit Low Input (TCM) (Us) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0707:00 (TCM, EV6A-EL, EV6AX-EL, US) DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
  • Record the freeze frame data/snapshot data.
    NOTE:
    • Recording can be facilitated using the screen capture of the PC function.
- Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
  • Verify related Service Bulletins, on-line repair information, or Service Information availability.
  • Is any related information available?
Yes Perform repair or diagnosis according to the available information.

Go to repair completion verification.
No Replace the control valve body, then go to repair completion verification.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [EV6A-EL, EV6AX-EL (US)] .)
Repair completion verification VERIFY DTC TROUBLESHOOTING COMPLETED
  • Clear the DTC using the M-MDS. (See CLEARING DTC .)
  • Perform the following procedure to ensure that the DTC has been resolved:
    1. Switch the ignition ON (engine off or on).
  • Perform the DTC inspection using the M-MDS. (See DTC INSPECTION .)
  • Are any DTCs present?
Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE (TCM) (US) .)
No DTC troubleshooting completed.